- After Power On Self-Test (POST), the following message will appear on the screen:
Pressto enter Raid Configuration utility
After the above message, press theand keys simultaneously. - Select option 1 Create RAID Volume and press the
key. - Select the strip value for the RAID 0 array by scrolling through the available values by using the or keys and pressing the
key. - The available values range from 4 KB to 128 KB in power of 2 increments. The strip value should be chosen based on the planned drive usage. Some suggested selections are listed below. The default selection is 128 KB.
' 16 KB !V low disk usage
' 64 KB !V typical disk usage
' 128 KB !V performance disk usage- As the Create Volume prompt, press the
key to create the array. Confirm this selection by pressing the key after the prompt. - Scroll to option 4 Exit and press the
key to exit the RAID Configuration utility.
Confirm the exit by pressin - Select option 1 Create RAID Volume and press the
You can easily access our extensive FAQ section, which is designed to swiftly address common queries and promptly resolve any issues you might encounter.
