Biostar

1.Please go to CMOS under Integrated Peripherals > OnChip IDE device.
2.Enable the On-chip Serial ATA in either Combined mode, Enhanced mode or SATA only.
3.Then set SATA Mode to RAID.
4.Save and exit the CMOS and now the SATA RAID function is launched.

Currently, Intel SATA RAID only support RAID 0 (Striping) function.

Intel SATA RAID only supports Windows XP Home Edition and Windows XP Professional.

Biostar P4TCA Pro, P4TSG Pro and P4TSE Pro that harness the Intel ICH5R (82801ER) South Bridge support Intel SATA RAID.

In order to not occupy the system resource, we had set the SATA function as Disabled under CMOS Setup Menu. Please follow below instruction to enable your system SATA function

1. Power On the system and then press the "Del" key to enter the BIOS Setup Screen
2. Choice Integrated Peripherals / On Chip IDE Device/ On-Chip Serial ATA
3. Set "On-Chip Serial ATA" function as Auto.
4. Press "ESC" key go to Main Setup Menu
5. Select "Save & Exit Setup" to complete the setting procedure.

Please follow below Instruction to install the USB Card Reader driver

1. Insert the CD Driver Into the CDROM
2. Access the CDROM content
3. Select DRIVER/CARD_READER
4. Double Click the Setup.exe file to start the Installation process.
5. Follow the instruction to finish the installation procedure.

The driver version V1.47B-1R and afterward able to perform Auto Run function. Insert the CD driver and select the USB Card Reader Icon, the system will install the driver automatically. You also can download this driver with following website
http://209.240.144.85/support/driver/iccard/iccard.exe

Note : The USB Card Reader Driver Is bundled under WinXP and WinME Operating System. Only Win98SE and Windows 2000 require to install the driver.

This Is because the Overclocking frequency that you had set Is out of CPU limitation. By following steps you can secure your system--

1. Removed The Power Core From The System
2. Closed The Jumper JCLK3
3. Plug-In The Power Core & Turn ON The System
4. Press "Delete" Key To Enter The CMOS Setup Menu
5. "Load Optimized Default" under the CMOS Setup Menu
6. Save and Quit the CMOS Setup Menu.
7. Turn The System Off
8. Open the JCLK3
9. Turn On the system

Note : Please refer to the User's Manual for JCLK3 location.

Please refer the Warpspeeder support description as following link. The U8788 board unable to support OverVoltage function, because the major chipset limitation.
-> https://www.biostar.com.tw/products/mainboard/socket_478/u8788/